I'm.on buddy club coilovers as low as I can go -1.5 degrees of camber I'm gonna buy some rota grids in the size in the title now my problem is I rub stock wheels and tires on the front fender over big bumps now so in trying to decide what tire size to get 205-50-16 seems to be the most recommended due to the diameter being closest to stock but I feel like I will rub bad so if anyone has any experience with a similar set up I would Apreciate it

 

If you're scared of rubbing, roll your fenders.

/end thread

 

that wasnt my question i know i could roll but im asking if anyone has this combo

 

I have 17 by 7 40mm offset on 205/40/17. I'm lowered on Tein coilovers with 2 finger gaps left. I also have camber bolts installed. NO rubbing whatsoever. I do not know how much i'm cambered currently, as coilovers were installed just yesterday and I haven't done my alignment yet.

 

2 finger gap between where ?

 

Well installed wheels and tires their 16x7 +40 with 195/50/16 kumho asx they rub a little on bumps on the front fender liners given I'm lowerd all.the way in the back and have them.flush up front on buddy club coiloverss with -1.5 camber upfront and -1.3 rear I got the kumho tires due to their narrow section width compared to the continentals I was looking at

 

i have 195/50 on my rpf1's with a 43 offset, i rubbed initially over bumps till the plastic started to deisapear haha

 

Yea I'm going with the same.logic wait till the plastic wears itself away