Instead of using one of those little filters on the end of the breather tube, I would like to vent to my homemade intake with a hose.

Where can I get the right size and type of hose to connect the tube to my SRI?

 

i've been wondering this too. i need to redo my line...i went to several stores and cant find the hose! home depot might have them?

 

i went by home depot today and they do have the hose. not sure on the size but i can get the size for you tomorrow after work.

 

thanks, I'll go by the local home depot and check it out.

 

does anyone know the size tube i would need for a vacuum tube, instead of using a breather.

 

Go to autozone or advanced, and ask for vacuum line, not hose. Vacuum line is typically a little stretchy, and you can get some up to 3/8 inch size. Use some silicone spray and itll go on.

 

thanks for the reply kirko, so the 3/8 of an inch over 5/8?

 

Where is a good place to get rubber plugs and grommets for the intake? My crankcase vent hose and plug/grommet have stretched and worn out a bit. I have tried hunting down the part numbers but have found nothing really useful. They don't often have the dimensions.

Is autozone/advance/oreily the best option? I get so sick of how UTTERLY useless the guys/gals at these shops are.

 

You mean like the grommets for the intake temperature sensor? You can get oem replacements from places like bernardi parts under parts > air cleaner

The plug/grommet for the breather hose is also on the same page, #1