I want to attach speedflow fitting to the hard line engine side and the fitting for intake side. What type of fitting would I use to take the hard line spots and make them - 6 an. I was looking at the speedflow -6an to 3/8 hardline fitting, but the intake inner diamter hole is 3/8 the outer is between 15/32 and 7/16. havent taken measurements of hardline breather hose connection. But it should be similar, or around those numbers. any suggestions on what to do?

 

Try it. Not being sarcastic, but pioneers seldom have soemething to work off of. Get a fiting, try it. Then post up a DIY for the community. Win.

 

I actually already did accomplish a way to do it. The tube that comes out that the hose attached to has a hump at the end. Not sure what it is called. Anyways, you have to get - 8 AN push lock hose. To secure the hose use a - 10AN screw crimp. Because the rest of my hose and stuff was - 6AN, a few reducers and extra fittings were used to connect the hoses to the catch can. If you want to see a completed look of every thing put together, and I have another post the is titled prm intake and oil catch can. If something to that nature. Hope this helps out.