has any had any problems with the supercard for the KWSC? or the MAP sensor stabilizer? i just threw a P107 Code (Low MAP voltage). i cleared it and it ran fine. but now i cant floor the pedal, it bogs out like its not getting fuel or cutting out. but it i drive with the pedal 75% it is fine.

 

You re-check your connection?

Also did you call or email KW? They would know better than anyone on here.

 

i checked the connections. i called and left a message

 

im on AOL IM with them now

 

Good luck man

 

the computer isnt reading and making it run too rich ?
did you try re-setting ur computer?

 

yeah, tried it. KW said to bring in the Electronics for warranty.

 

I had the exact same P0107 problem pop up, made my car go to limp mode for a little while. Thought it was the MAP stabilizer but it was actually the wire connection going bad.

Electrical connections looked fine, but I found out that moving around some of the wires would cause the engine to stall/die, throwing the MIL in the process. Turns out that where the MAP stabilizer connects to the middle wire of the MAP sensor plug, the wire was just about to break (and it did break once I found out).

Try moving your wires around and see if it causes problems.

 

i changed the connections for the MAP, didnt help. so im going to bring the MAP stabilizer into KW andhave them look at it.

i cant rev hard at full throttle, but if i use like 50-75% throttle it runs fine.

i had scene an older post u posted, how much did you pay for the new MAP sensor?

 

37830-PNC-003

Bernardi Parts has it for sale at ~$54 before tax+s/h... I bought mine for around $70-80 shipped back then.

 

Hope you get it all worked out!

 

i changed the Map stabilizer, no difference. going to change the Map sensor 2morrow

 

changed the MAP sensor and the MAP stabilizer.... No FIX. Going to check the wires 2morrow.

Thanks to KraftWerks (OJ jr) for swapping out the Map stabilizer with out any issues.

 

Tagged for interest...

 

i changed the MAP sensor and the KWSC MAP stabilizer... No fix. i took off the Map stabilizer and the car runs fine

 

im going to try a MAP Bypass Valve

 

Did you ask KW if this would be wise? I still think it is a connection problem. This is what it continues to sound like. Do you possibly have it connected backwards?

 

The MSS is installed like in the instructions, i just talked to KW. im going to take the car in and have them look at it.

 

KraftWerks saved the day... They fixed my issue. it was the Supercard (My fault, i got it wet). they helped me out and they fixed it. car runs great. now im going to switch out to 10psi.

Big THANKS to OJ jr and OJ @ KraftWerks for helping me out. Best customer service by far from any company I've ever done business with