Replacing wheels myself, help!
#1
Replacing wheels myself, help!
I got some snow tires+steel wheels on Craigslist for my 2010 Sport, and tried installing them just now. The new wheels are supposedly from a 2006 Scion xB, which is supposed to have the same bolt pattern and similar offset.
Anyways the bolts fit perfectly in the wheels, but the circular opening in the center isn't fitting over the axle (is that the right term?). It seems like the opening on the new wheels is about ~1mm smaller in diameter than the stock Sport wheels.
Quick MSpaint to hopefully illustrate what I'm trying to say: http://imgur.com/qhZeOZl
Is this normal? bad? If bad, are the wheels the wrong size, or do I need to use wd-40 or something something to get them on? I tightened the bolts standing-on-wrench tight and it's only overlapping 1-2mm at best.
Anyways the bolts fit perfectly in the wheels, but the circular opening in the center isn't fitting over the axle (is that the right term?). It seems like the opening on the new wheels is about ~1mm smaller in diameter than the stock Sport wheels.
Quick MSpaint to hopefully illustrate what I'm trying to say: http://imgur.com/qhZeOZl
Is this normal? bad? If bad, are the wheels the wrong size, or do I need to use wd-40 or something something to get them on? I tightened the bolts standing-on-wrench tight and it's only overlapping 1-2mm at best.
Last edited by degnaw; 12-21-2014 at 10:38 PM.
#2
A quick look on google looks like the scion has a 54mm hub bore and the fit is around 56mm so that might be your problem there. I wouldn't drive on the wheels since the probably are not on straight.
Thread
Thread Starter
Forum
Replies
Last Post
_nifty_
2nd Generation GE8 Specific Wheel & Tire Sub-Forum
2
03-15-2019 11:27 PM