New Project..
#231
Gauges and modular harness being made for me by ISSPro, should be here beginning of next week.
This wiring shits never gonna end:
Nevermind the goofy electrical tape job and weird wire gauge change on that relay. The main lengths for power, trigger and ground are run in 8ga for complete overkill so to avoid voltage drop and overheating. Will be soldered properly before first crank.
Pins on the Relay are smaller than I wanted, so looking at jamming the 8ga into 10ga spade terminal receivers and then soldering those to the relay pins. Dash switch and relay rated to 30A, draw max from that pump should barely get into the teens so not worried.
This wiring shits never gonna end:
Nevermind the goofy electrical tape job and weird wire gauge change on that relay. The main lengths for power, trigger and ground are run in 8ga for complete overkill so to avoid voltage drop and overheating. Will be soldered properly before first crank.
Pins on the Relay are smaller than I wanted, so looking at jamming the 8ga into 10ga spade terminal receivers and then soldering those to the relay pins. Dash switch and relay rated to 30A, draw max from that pump should barely get into the teens so not worried.
#235
This is going to make some noise:
Two waste-gate dump tubes and the turbine discharge all going through the hood.
Should make for quite a fireball show at night too bouncing off the two-step and under full boost when the gates crack open
Two waste-gate dump tubes and the turbine discharge all going through the hood.
Should make for quite a fireball show at night too bouncing off the two-step and under full boost when the gates crack open
#236
Looks like you have a beast on your hands. Nice work.
#239
Rolling meth lab!
Tank is too small, but what I have for now. With the 3 nozzles I'm using (1x 10gph, 2x 2gph) spraying @ 220psi I should be out of fluid in about 3 miles lol
Tank is too small, but what I have for now. With the 3 nozzles I'm using (1x 10gph, 2x 2gph) spraying @ 220psi I should be out of fluid in about 3 miles lol
#240
Anyone have any experience with Push-to-Lock DOT lines?
Looking to try some out for my WasteGates/BOV/AFPR, like this:
Recommended by a friend, and I know some folks use them.. I've only ever used the nylon type that come on meth kits
Looking to try some out for my WasteGates/BOV/AFPR, like this:
Recommended by a friend, and I know some folks use them.. I've only ever used the nylon type that come on meth kits