[jadr09fit]

Put the films on yesterday. Glad we did the wet method, as we had more time to get the placement right.

For the 09's, there's 1 10mm screw in the upper corner of the housing. Take that out, then swing the foglight out. The side closest to the grille swings toward the fenders a couple inches, then you're able to pull the foglight out. Take off the clip for the bulb, and the foglight is free. To get to the light, take out the three screws holding the housing to the light.

Installation is the same as removal. After re-assembling the light and housing, re-connect the bulb sockets. Then, angle the foglight just like you took it out, then slide it back in a couple inches. Push the inside corner in. This should make the outside clips catch, and get the single inside clip to catch. You'll know it's clipped in when the foglight can be gently wiggled without moving much. Don't forget to put back the 10mm screws to finger tight.

This is posted as a guide for foglight removal on the 09's, we take no responsibility for any damages incurred following this guide.