GE muffler cross section
#1
GE muffler cross section
I deleted the muffler... replaced with straight pipe (for a tiny fraction of the cost of a J's Ti piece!). While I was at it, I cut the muffler in half to see what the innards look like... take a look:
https://www.flickr.com/photos/170327...7648347409875/
https://www.flickr.com/photos/170327...7648347409875/
#3
Wow! Thanks for sharing! This is the type of stuff I like to see. A straight pipe should do wonders after removing that piece. Nice work with the pics.
Could you share the path of the flow as it comes through the inlet? I see ports 'A' and 'B' but hard to decipher the direction of the flow before it leaves the muffler. Does it come in the inlet, through 'A', then 'B', then to the outlet?
Nevermind! After staring at it for about 2 minutes, I got it...somewhat. That is NUTS!
Could you share the path of the flow as it comes through the inlet? I see ports 'A' and 'B' but hard to decipher the direction of the flow before it leaves the muffler. Does it come in the inlet, through 'A', then 'B', then to the outlet?
Nevermind! After staring at it for about 2 minutes, I got it...somewhat. That is NUTS!
Last edited by Myxalplyx; 10-04-2014 at 06:53 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Arisenfury
Fit Engine Modifications, Motor Swaps, ECU Tuning
32
04-16-2013 03:26 PM
07fitsport
Fit Engine Modifications, Motor Swaps, ECU Tuning
7
05-16-2008 11:03 PM
K20A3Fit
Fit Engine Modifications, Motor Swaps, ECU Tuning
12
02-19-2008 02:52 PM
Aerodynamic Head
Fit Engine Modifications, Motor Swaps, ECU Tuning
3
09-14-2006 12:51 AM