2010 Fit A/C Clutch bearing failure
#1
2010 Fit A/C Clutch bearing failure
IS it common for the A/C clutch bearing to fail with under 90k miles on the engine? It hasn't seized yet but it's about to for sure. I verified it is indeed this bearing that is going. I have 88k miles on the engine now and it had started getting noisy about 10k miles ago. Seems premature that the AC compressor clutch bearing is failing before the cars 1st break job!!!
#4
I have not seen one fail personally and yes under 90k does seem premature for a failure but it could happen.
I would advise you to replace as soon as possible to avoid damage to the compressor snout.
I would advise you to replace as soon as possible to avoid damage to the compressor snout.
#6
All Fixed
I replaced the pulley and bearing today. I had to buy a used compressor to get the parts I needed. Replacing wasn't to difficult. I did have to use a gear puller, but that was the worst of it. The bearing was shot.
Thread
Thread Starter
Forum
Replies
Last Post
TroyGgd3
1st Generation (GD 01-08)
12
10-26-2016 08:30 AM