2015+ Short Shifter...
Member
Joined: Jun 2018
Posts: 461
From: Mayagüez, Puerto Rico
After 2 1/2 years... and actually keeping the car. I bought the acuity and short shifter a long with a dremel to trim the parts on the short shifter from buddy club. Couldn't wait for acuity to finally sell their version. Anywho... I installed the Acuity shifter bushings first and I gotta say it may the car feel better. More mechanical. Then I installed the short shifter, I sliced my finger open, and a few bad words in spanish later... I like the outcome of the short shifter. 
I followed this to remove the center console. https://www.youtube.com/watch?v=aI-RpjicOgw
If you have the center console arm... there is two screws on the lower back of the center console... you gotta remove the plastic bezel in the back where the rear seats are at. I'll post photos after my hand heals of what I am talking about lol...
I followed this to remove the center console. https://www.youtube.com/watch?v=aI-RpjicOgw
If you have the center console arm... there is two screws on the lower back of the center console... you gotta remove the plastic bezel in the back where the rear seats are at. I'll post photos after my hand heals of what I am talking about lol...
I'm from Puerto Rico
Thread Starter
|
New Member
Joined: Mar 2009
Posts: 19
From: Fullerton, CA
I was born in California. My parents are from El Salvador and they taught me to speak spanish as my first language.
Member
Joined: Jun 2018
Posts: 461
From: Mayagüez, Puerto Rico
Thats cool!!! Having your folks to keep the Latin part of you alive by teaching you the language... as well as your customs!!! Kuds for them!!!
Im Manuel, from Puerto Rico!!
Nice to know there are other LATINOS here!!!
Thread Starter
|
New Member
Joined: Mar 2009
Posts: 19
From: Fullerton, CA
Member
Joined: Jan 2020
Posts: 222
From: Australia
Will the buddyclub shifter work for the 2019 GK5?
Member
Joined: Jun 2018
Posts: 461
From: Mayagüez, Puerto Rico
De nada Erick!! BTW
There might be info either here on FF or on the web... not sure... for the small mod that has to be done to the shifter to be able to clip the cables from the GK...
There might be info either here on FF or on the web... not sure... for the small mod that has to be done to the shifter to be able to clip the cables from the GK...
Member
Joined: Jan 2020
Posts: 222
From: Australia
I found it all mounting bolts line up but the center section for the cable is too narrow has to be shaved to fit? Hmmmm..
Last edited by RD36; Nov 17, 2020 at 01:49 AM.
Thread
Thread Starter
Forum
Replies
Last Post
cptjon
3rd Gen GK Specific Fit Engine Modifications, Motor Swaps, ECU Tuning Sub-Forum
4
May 20, 2015 07:32 PM
impreza
Fit Engine Modifications, Motor Swaps, ECU Tuning
190
Oct 9, 2014 07:18 PM
Vash
2nd Generation (GE 08-13)
3
Apr 17, 2012 09:28 AM