What did you do to your GE fit today?
#8361
anyway, set-up an appointment for my 5000 mile service (oil change) @ 6500 miles. First oil change in almost a year. also, i put in for the vsa recall notice which i received yesterday.
#8363
These guys tried smoke plasti-dip and went to black with gloss coating for taillights Plasti Dip Taillight Tinting
How many coats did you apply?
How many coats did you apply?
Last edited by cjecpa; 05-22-2013 at 01:26 PM.
#8364
These guys tried smoke plasti-dip and went to black with gloss coating for taillights Plasti Dip Taillight Tinting
#8365
These guys tried smoke plasti-dip and went to black with gloss coating for taillights Plasti Dip Taillight Tinting
How many coats did you apply?
How many coats did you apply?
#8366
Red Smoke Tint Film
#8373
#8374
Well, this would technically be "yesterday" as it's just past midnight now.
Got home after work, pulled off the door panel, yanked the old actuator, put in new, then replaced the door panel.
All quiet again.
Backstory: last week, my door lock actuator started to fail. at first it was a LOUD clank when locking. immediately after posting a thread about it, it changed to a grinding noise. I think the actuator uses a worm gear. And I'd guess the gear teeth got messed up. Ordered a part from Bernardi, arrived on Tuesday, but put off the repair job as it was late after work. Well, after work "today" was late too, but enough was enough. That grind is rather startling.
edit: some one needs to learn to crop/resize pictures... there comes a point where big is too f-ing big. and at nearly THREE times the width 1920 pixels would be it.
Got home after work, pulled off the door panel, yanked the old actuator, put in new, then replaced the door panel.
All quiet again.
Backstory: last week, my door lock actuator started to fail. at first it was a LOUD clank when locking. immediately after posting a thread about it, it changed to a grinding noise. I think the actuator uses a worm gear. And I'd guess the gear teeth got messed up. Ordered a part from Bernardi, arrived on Tuesday, but put off the repair job as it was late after work. Well, after work "today" was late too, but enough was enough. That grind is rather startling.
edit: some one needs to learn to crop/resize pictures... there comes a point where big is too f-ing big. and at nearly THREE times the width 1920 pixels would be it.
Last edited by Goobers; 05-23-2013 at 01:49 AM.
#8377
Takes up two of the cup holders, everything's bolted and secure, doesn't just sit there. and was incredibly easy to install. Took maybe 30 minutes.
I'd definitely recommend it. Bought it for $175 on amazon.