Might've found what I needed for something I've wanted to do for a long time: Custom grille. I've never liked either of Honda's options for grilles, so here's hoping the stock one I found doesn't sell so I can use it as a base. I haven't seen one go for this cheap before, and I haven't seen any Fits in junk yards at all, so here's hoping.

 

17" Proline Alloy 38 offset
Stock suspension
FINALLY!

 

Yeah it looks exactly the same n0thing.
maybe needs to settle

 

Progress springs don't lower it much. 1-1.25" or so up front and hardly anything in back. It looks lowered in person but it's by no means slammed. It's a budget autocross setup so it's more about performance than looks.

 

^ if your just looking for a sportier set up then I think its fine, but a lot of guys here look for a visual difference and measure by that.

Too each their own

 

Maybe its just harder to tell from pics. But if youre happy with it thats all that matters.

 

Upgraded my 4Kg Tein Street Flex' Springs to 5Kg Swift Springs and installed the HARDRACE Front Reinforced Strut Mount (Hardened Rubber Strut Mount)






Then washed and gave it a coat of Carnauba Wax

 

Finally had some time to get my car washed and waxed.

 

looking good...color is very nice

 

Whats the shield youre using under the engine bay?

 

bought a diagnostic code reader but "IMMEDIATELY RETURNED"
upon learning it was homemade in demonic communist china !!!!!!

-----( AMAZON.COM / etc. SHOULD PUT A WARNING NEXT TIME IT SELLS SOMETHING MADE FROM COMMUNIST CHINA!!!!)-----

 

 

Thanks phenoyz! Was going for the stealth look...

Hey Conner, It's the Beatrush Under Panel (the blue is the protective plastic film)
UNDER PANEL

 

Beautiful car!

 

My NOAH car cover all season cover failed and allowed all kinds of dirt and material through it during out last rain storm. I have mailed it in for a warranty return and should see something in the next week.

Gave it a quick wash just to get the residue off the roof and hood



I hate having my car sit outside uncovered but will just give it a quick rinse if it gets too dirty



Quality setup!

 

I washed both of my Fits. Love both of these colors.

 

Finally found the time to install JDP CF spoiler, diffuser, and lip.

 

^hows the fitment? I ask cause Mine isn't perfect. There are slight gaps on the left and right edges just past where the bolts go in. Its not perfectly curved to the top of the hatch. I think jdp will help me out with that though.

Its not much but its just enough that the tape wont make contact with the hatch on those outer corners...

 

Nice! Where can I get one of these spoilers?! #NEED

 

Not sure if serious, or just not reading...lol