***Update***!!!
After 8 hours of hard work and prepping the engine bay and prepping the motor to be test fitted so that I knew that the chassis modifications were adequate, THE ENGINE IS SITTING PROPERLY IN THE ENGINE BAY!!!!!
It does have to come back out, but at least I''ve crammed it in there and I can do it again!
Here she is getting ready for me to work on her!
Here is the Fab work:
Took off manifolds as to not have it complicate maneuvering the engine around in the bay, (And not to break sensors).
Moved brake lines off of those white clips and carefully bent them out of the way up onto the frame rail.
Cut the Radiator supprt in order for the intake manifold to clear!
Modify passenger engine mount:
Modify Drivers side frame rail to clear transmission case.
And cut the drivers side mount a bit to clear as well.
Start putting the engine in!
Watch out for the T-case and the drain plug on the rear sub frame!
How we positioned it using an engine hoist (cherry picker)
Drivers side Transmission mount and bracket (got lazy didn't put in the rear, Pretty sure it should fit!)
Passenger side Engine mount bracket:
There it is test fitting done, Now it's time to take it out again and put in a new clutch and do the wiring and the header and axles!
Stay Tuned!