De36's GE8
#184
It's pretty bad. The issue with my design is that you can not reinstall the center console. I don't have my console installed so it's not an issue.
But I would like to find a solution that would accept the console without increasing throw.
But I would like to find a solution that would accept the console without increasing throw.
#185
Figured this would be an issue. When I was trying to get the h-fit extender onto the revo I had to use spacers. The spacers didn't even add up to an inch and the center console almost didn't fit and my cup holders would come loose on hard shifts lol. Don't know if I'm ready to give up my cup holders since I still daily the car. But I am definitely willing to give this a try.
#189
You're correct. There is a bracket that needs to be modified to gain the "slack" to relocate the entire assemble; it's the least of my concerns.
#191
Figured this would be an issue. When I was trying to get the h-fit extender onto the revo I had to use spacers. The spacers didn't even add up to an inch and the center console almost didn't fit and my cup holders would come loose on hard shifts lol. Don't know if I'm ready to give up my cup holders since I still daily the car. But I am definitely willing to give this a try.
#192
Only if paired with a full short shifter assembly that you've had to raise to clear the bottom part. Others have just taken a hammer to the portion of the body that prevents the shifter from going into 1st/3rd/5th. Hope that makes sense
#193
Yeah it makes sense.
#194
4" Shifter Extender and Skunk2 Short Shift
Installed, Very comfy orientation. the throw is ~4.5"
4" Shifter Extender:
Skunk2 Short Shift:
Knob to Wheel relationship:
4" Shifter Extender:
Skunk2 Short Shift:
Knob to Wheel relationship:
Last edited by De36; 07-29-2015 at 02:06 PM.