What did you do to your GK Fit today?
#190
Tanabe Strut Tower Brace
Today the Tanabe Strut Tower Brace made its way into the car. It's a very straight forward install with 10mm, 13mm, and 17mm socket set. I was disappointed to discover that the brace doesn't actually mount to the towers but instead to a unibody point forward of the towers and two of the upper fender braces.
#193
It's a good look
Drummingfish, I thought my white on red was sharp, but black on white is a clean look too. It looks like something Honda would/should have done, but only a Fit owner knows that. A nice detail for just a few bucks!
Last edited by JimTheSoundGuy; 05-17-2015 at 10:16 PM.
#194
I have to get another decal, the c tore and peeled apart on the drivers side haha, 4 bucks down the drain :-P
Love the white on red. Was trying to decide red or black, found these red "i" ones and figured it was the best of both haha.
Love the white on red. Was trying to decide red or black, found these red "i" ones and figured it was the best of both haha.
Last edited by thedrummingfish; 05-18-2015 at 02:03 AM.
#195
The wheels? What are they? Size, ET please..
Sorry, saw the post now.. How did you manage to roll fronts? I gave it a try but the fenders are sooo soft to deal with..
Sorry, saw the post now.. How did you manage to roll fronts? I gave it a try but the fenders are sooo soft to deal with..
Last edited by CN_Fit; 05-18-2015 at 01:40 PM.
#198
I'm looking to go for 1.5~1.7deg, 4 seems too much. This affects acceleration and breaking too much, not to mention tire wear.
As far as fender pulling I actually bought a puller for it but it is just not applicable, way to soft. Simple and careful hand pull sufficed.
#199
It's been adjusted since then. I'm at around -1 in front. But camber isn't the problem. It's the toe adjustment. Also a word of advice, when u roll the rear, there are TWO layers of metal. The outside quarter panel and an inner part. Make sure they're right next to each out while rolling or you're going to have a bad time.