When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Well, I have had my 2019 Sport CVT about a week and a half now and have done these few things
Kuga 3D floor mats
SuperBright LEDs headlight bulbs
Pilot Sport mini antenna
Weathertech front window reflectors.
To do:
Have to install my HFP rear spoiler, yellow foglight film, iJDMTOYS rear pillar leds, catch can and waiting for my Bisimoto pulse chamber to show up as that is my priority! I need a little noise as it kills me to drive a quiet car!
Also trying figure out if I want a Takeda intake or something else. This is fun
Wow, looks good Can I ask how you got your fogs out? I need to pull mine so I can tin the lenses yellow. Thanks
honestly I didn’t take them out. I just pulled the bulb and wiring from under its easy access. But I’ve pulled the bumper off before to install the red H badge and it wasn’t too bad tbh.
The fog cover pops out the cover is just clip on the bumper and then remove 2 screws and the fog light housing comes out and then unclip the light harness
Thanks guys, will give it a go. I tried to pop it out the other day with a butter knife wrapped it tape but was nervous about breaking something on a car with 300 miles on it. I will be a little more confident this time. Hopefully the first snow of the season dissappears quickly
This is the passenger side, which in the GK's at least a bit more tedious since there is WAY LESS space to tinker with....
As soon as i recieve the fog lamp covers and do the drivers side, ill do another slide show...🤪😬
Spectre 90⁰ bend and flexible intake tube Spectre 90⁰ bend Drank a beer in the process 😬 Used a 2¾ or 2⅞ hole saw... cant really recall the size Testing the 90⁰ bend on hole i made The shinny dot is the 90⁰ bend viewed from the front bumper as I fit tested Routed the Spectre flexible "intake" duct along the underside plastic cover, will hold them in place with some mighty heavy duty cable tie wraps Almost, almost finished, as soon as the fog lamp covers arrive....
Fog lamp / \"brake duct cooling intakes" arrived! Inside look.... those are the connecting rubbers from the flexible intake... How it looks once installed... in this pic i haven't installed the flexible part... That's how it looks now....
No useful pictures, but changed the starter today. Once I figured out how to reach the top bolt, ended up being a relatively easy job. Had to remove four sensor wires at the top of the harness in front of the engine, but didn't have to remove the coolant tank or oil filter to get the starter out once the bolts were removed.
Routed the Spectre flexible "intake" duct along the underside plastic cover, will hold them in place with some mighty heavy duty cable tie wraps Almost, almost finished, as soon as the fog lamp covers arrive....
elkaku
lookin good! where is that being routed to? to cool the brakes? to feed the intake?
Hi guys! I lowered my GK5 with D2 springs and changed the wheels and tires from the stock 16"s. I'm going to change the tires I should've got a taller sidewall.
Hi guys! I lowered my GK5 with D2 springs and changed the wheels and tires from the stock 16"s. I'm going to change the tires I should've got a taller sidewall.
Can I ask how you got your fogs out? I need to pull mine so I can tint the lenses yellow. Thanks
